Baliaca lis 80 t so špeciálnym lisovacím rámom pre náročné materiály

Avermann Maschinenfabrik GmbH & Co. KG AVOS 1410-45/80

Technical data baler:

Manufacturer: Avermann Maschinenfabrik GmbH & Co. KG, Germany
Model: AVOS 1410-45/80
Year of manufacture: 2009
Operating hours: 22,029 hours, as of December 2025
Pressing force: 80 kN
Specific pressing force: 103.9 N/cm²
Feed opening dimensions: 1,400 x 1,000 mm
Theoretical cycle time: 12 seconds
Theoretical throughput: 300 m³/hour
Bale dimensions: 1,100 x 750 mm (W x H), length adjustable
Drive power: 45 kW
Total connected load: 75 kW
Binding: 4-fold vertical, fully automatic
Throughput capacities at a bulk density of:
- 30 kg/m³: approx. 6.0 t/hour
- 50 kg/m³: approx. 10.5 t/hour
- 100 kg/m³: approx. 17.5 t/hour
Bale weights (bale length approx. 1.2 m): up to 600 kg, depending on material
PLC control: Siemens S7-300
Display panel: pulsotronic
Installed press dimensions: 8,610 x 2,400 x 3,835 mm (L x W x H)
Transport weight (baler): 16 t

Special equipment:
- Wear-resistant floor made of HARDOX steel
- Special press ram for compacting "difficult" materials and loose bulk materials of small particle size
- Control cabinet air conditioning
- Machine base elevation 200 mm

Remarks:
The machine was serviced and partially overhauled in our workshop. The following tasks were performed and parts replaced:

• Disassembly of the press ram, breakdown into individual parts, overhaul of the mechanism, replacement of the following plastic wear plates and rails:
o Plastic wear rails left/right under the press ram
o Plastic wear rails left/right above the press ram
o Central plastic main wear plate (support plate) under the press ram
• Steel guide rails left/right at the top of the frame replaced
• Complete base plate replaced (in four sections), made of wear-resistant HARDOX steel
• Wire feed rails in the press base newly welded and smoothed
• Counter knife assembly (two-part) in the frame replaced
Kodpfxjx A U Nco Ac Nslr
• Knife gap adjusted to approx. 2.5 mm
• Disassembly of the tying and twisting unit, breakdown into individual parts, overhaul of the mechanism, replacement of all groove ball bearings and axial ball bearings of the twisting shafts, wire cutters cleaned and re-aligned, chains lubricated and tensioned
• Carrier roller in front of the twisting shafts replaced
• All hydraulic hoses replaced
• Oil and air filters replaced
• Main hydraulic cylinder checked for leaks
• The hydraulic oil is only one year old, chemically analyzed, in good condition and therefore has not been replaced and can continue to be used
• General maintenance performed

Afterwards, the baler was subjected to a machine test in manual and automatic mode (see video of machine function test).

Inzerát bol automaticky preložený. Chyby v preklade sú možné.