Nízky nakladač

Fliegl ZTS 200 P

More information
Chassis low-loader trailer
Steel welded construction
Turntable with robust ball bearing slewing ring, storage box integrated into the turntable front section
Foldable rear support
Wheel chocks with holder
Aluminium side underrun protection
Half-shell mudguards on 1st axle, quarter-shell mudguards ahead of and behind the 2nd axle
with anti-spray mud flaps behind each axle
1 plastic tool box with shelf, W=620/H=360/D=440 mm, lockable with a padlock (lock not included)
Extendable width up to 3,000 mm (not in rear bevel area)
(The track width of construction machinery or vehicles to be transported must not exceed the outer frame width of 2,550 mm), central stowage compartment for wooden planks in the center of the loading area, 70 mm wooden planks for widening to 3,000 mm
Lashing eyes low-loader
3 pairs of lashing points, 10t each, integrated into the floor at the front
6 pairs of lashing mushrooms, set into the top and sides of the outer frame, 10t each
1 x located near neck area, remainder distributed in between, spacing not greater than 1,200 mm
1 x rear ramp area
5 pairs of ring lashing eyes set into the outer frame, 5t each (instead of stake pockets)
Trailer turntable coupling
Drawbar with certified 40 mm towing eye
Axles & suspension
SAF drum brake axles
Axle/chassis laser alignment reduces tire wear and fuel consumption
Parabolic suspension with maintenance-free steel/rubber bush
Wheels and tyres
235 / 75 R 17.5
manufacturer’s choice
Steel twin wheels, factory silver
Braking system
2-line compressed air brake system
Spring-loaded parking brake
2 non-interchangeable coupling heads at the front with connector lines to towing vehicle
ABS and ALB, with ABS connector at the front and connection cable
Note: The trailer may only be towed by vehicles ensuring the effectiveness of the ABS!
Electrical system
24 volt, multi-chamber lights, side yellow LED lighting
2 white/red marker lights at the rear
Dsdpji Ri N Hofx Agnswc
2 white position lights at the front
1 rotating beacon with holder, switchable via parking lights (removable beacon)
2 pairs of warning panels, double LED lit and extendable up to 3,000 mm
2 x 7-pin non-interchangeable plugs at the front with connection cable
Flooring
Front section steel floor
Rest with 70 mm softwood flooring, wheel arch area with steel/chequer plate covering
Rear ramp section with 70 mm softwood flooring
Low-loader deck including ramp area 8,200 mm
Ramps
Steel ramps, 2,800 mm long, 750 mm wide, laterally adjustable
additional ramp safety bracket, foldable below (prevents lateral sliding of the ramps, not for use with hydraulic lateral ramp shift)
wooden inlay
with spring lift assistance
Operating notes
A special permit is required for a 10,000 kg axle load. The permit must be applied for individually in each federal state; compliance for 20t GVW does not have to be guaranteed by law. Customer’s risk.
The total stated weight is technically possible, but the permissible total weight may not be achieved depending on the load while complying with permissible axle/support/kingpin loads.
Registration / Number plates
Country of registration: Germany
Certification according to EC 2007/46
24/7 service hotline
prepared for double-line number plate holder
Contour marking with reflective tape according to ECE R 048, white on the sides and red at the rear
Warning sign according to ECE - 70
Paintwork
Frame DB Nova Grey
Ramps hot-dip galvanized

Note: Archive images!

Inzercia bola automaticky preložená a vyskytli sa nejaké chyby prekladu.