Frézovačka ozubených kolies - horizontálna

MIKRON A 33/1

Wheel diameter – max. 80 mm
Wheel width 150 mm
Module – max. 2.5
Module – min. (not specified)
Total power requirement 10 kW
Machine weight approx. 2,400 kg

Fully automatic gear hobbing machines for worm gear cutting
Model A 33 / 1 Year of manufacture: 1985 Serial No.: 14.06/14.07/14.15

TECHNICAL DATA:

Maximum workpiece diameter – without loading magazine: approx. 80 mm
Maximum workpiece diameter – with loading magazine: approx. 50 mm
Module max.: 2 / 2.5
Axial cutting length: approx. 150 mm
Max. workpiece installation length: approx. 200 mm

Swiveling range of milling slide: up to 90 degrees
Cutter diameter: 24 – 50/63 mm
Radial travel of milling slide max.: 0-14/18 mm
Cutter slide shift max.: 25 mm
Cutter speeds: 212 – 2,000 rpm
Axial feed range, infinitely variable: 0.05 – 4.0 mm/rev
Radial feed, infinitely variable: 0.2 – 200 mm/min

Milling spindle drive: 3 kW
Total drive approx.: 10 kW – 50 Hz – 380 Volt
Weight approx.: 2,400 kg

Accessories / Special features:
Fully automatic operation with minimized idle times through freely programmable SIEMENS program control S5 for all machining steps, such as rapid traverse, feed rate, cutter on/off, for the loading system, tailstock, possible shifting, etc., as well as with part counter, program numbering, and 30-level numerical error display.

Pneumatic workpiece loading and unloading device, parallel to the workpiece axis, suitable for shaft-type workpieces approx. 140 mm long x 8 mm diameter, with pneumatic double gripper for loading and unloading workpieces; raw parts are placed externally in change cassettes and inserted into the loading device.

The double gripper inserts parts between workpiece spindle and tailstock; the tailstock quill pushes parts into the main spindle collet and clamps them simultaneously. Finished parts are ejected from the main spindle and, via the gripper, placed back into the (finished parts) cassette. The complete process is electrically monitored and controlled. The entire loading device is encased in Plexiglas.

Hydraulic workpiece clamping system with collets and hydraulic ejector
Separate coolant unit with magnetic separator * separate hydraulic power unit * various change gears

Blsdpst Hw D Rofx Aaleg
Condition: Good – 3 machines available, currently 1 machine ready for demonstration, under power.

The machine is set up for cutting worm shafts/armature shafts commonly used in variable gearboxes for car seats, window regulators, etc.

Inzerát bol automaticky preložený. Chyby v preklade sú možné.