Širokopásová brúska

SCM DMC SD 60 - RCS 110

- NEW -

GENERAL FEATURES:

Machine Frame and Work Table
* Steel construction with electrical control cabinet at the front of the machine
* Insertion of sanding belts from the left side of the machine
* Motorized table height adjustment
* Main motor integrated in the machine frame

Electrical Equipment
* Electromechanical control panel on the left front side of the machine
* Automatic star-delta start for the main motor
* Motor protection switches for the motors
* Motors with insulation class IP 54

Emergency and Protection Devices
* Safety microswitch for thickness excess
* Automatic brake for immediate stopping of the units
Fpjdevwfrnjpfx Agusn
* Emergency stop bar at workpiece infeed
* Mushroom emergency stop buttons at workpiece infeed and outfeed
* Lockable main switch
* Automatic emergency shutdown of the machine in case of:
- Sanding belt tear
- Sanding belt not tensioned
- Lateral belt run protection
- Insufficient compressed air
- Main motor overload

Note: The standard version with 400 Volt 50 Hz requires a three-phase power supply + neutral + earth. If the 400 Volt power supply is without neutral, a single-phase transformer from the price list must be ordered. The same transformer must also be ordered for machines with a voltage higher than 400 Volt, regardless of whether a neutral is present or not. Machine versions with 220 or 230 Volts (50 or 60 Hz) are available at extra cost (see price list).

STANDARD BASIC MACHINE EQUIPMENT
- R140/85 rubber-coated calibration roller, dia. 140 mm, 85 Sh - 1st position
- R160/45 rubber-coated sanding roller, dia. 160 mm, 45 Sh - 2nd position
- Hard sanding pad with manual adjustment of working height
- Main motor 11 kW (15 HP)
- Electronic ammeter for the main motor to display current consumption
- Electronic display of working height
- Electronically controlled sanding belt oscillation
- Rubber pressure rollers
- Kickback protection at infeed before the first unit
- Rubber feed belt 60 Sh
- Roller table with two rollers at the infeed and outfeed of the work table
- Feed belt with two speeds 4.5 / 9 m/min with gear motor
- Automatic belt centering

Working width mm 1,100
Min./Max. working height mm 4 - 170
Sanding belt width mm 1,115
Sanding belt length mm 2,150
Main motor power kW (HP) 11 (15)
Feed gear motor kW (HP) 0.45/0.8 (0.6/1.1)
Feed speed m/min 4.5/9

Consisting of:

10.90.87 European safety regulations (CE mark)
93.07.31 Voltage 400 EU
93.12.01 Frequency 50 Hz
44.44.19 Version "B" for RCS
33.31.50 Roller table at infeed and outfeed for long workpieces
62.44.50 10" control panel with "eye-S" software integration
31.21.60 "RA" spiral-grooved steel contact roller - 1st unit
97.50.71 Main motor 15 kW (20 HP)

Inzercia bola automaticky preložená a vyskytli sa nejaké chyby prekladu.